Agent Bottleneck Record: CT Inspection Throughput

Schema: addithive-agent-record/v1.1 · Record type: bottleneck · Valid as of: 2026-08-12

{
  "affected_steps": [
    "final inspection",
    "quality release",
    "qualification",
    "serial production"
  ],
  "bottleneck_layer": "inspection_and_ndt",
  "canonical_url": "https://addithive.com/ct-vs-conventional-ndt-additive-manufacturing/",
  "claims": [
    {
      "claim": "Addithive's Bottleneck Map identifies CT throughput and defect acceptance criteria as inspection constraints for industrial AM.",
      "claim_type": "fact",
      "confidence": "high",
      "evidence": [
        "source:bottleneck-map"
      ]
    },
    {
      "claim": "Addithive's aerospace qualification guide identifies CT resolution, NDT access and defect acceptance criteria as inspection-qualification bottlenecks.",
      "claim_type": "fact",
      "confidence": "high",
      "evidence": [
        "source:qualification-guide"
      ]
    },
    {
      "claim": "Inspection can become the system constraint even when printer capacity is available.",
      "claim_type": "analysis",
      "confidence": "high",
      "evidence": [
        "source:throughput-guide"
      ]
    }
  ],
  "failure_modes": [
    "CT queues",
    "insufficient defect detectability",
    "geometry-driven resolution limits",
    "manual report review",
    "unclear acceptance criteria"
  ],
  "id": "addithive:bottleneck:ct-inspection-throughput",
  "last_verified": "2026-08-29",
  "name": "CT Inspection Throughput",
  "record_type": "bottleneck",
  "record_url": "https://addithive.com/2026/08/12/agent-bottleneck-ct-inspection-throughput/",
  "relationships": [
    {
      "from": "CT inspection throughput",
      "relation": "constrains",
      "to": "accepted-part throughput"
    },
    {
      "from": "complex internal geometry",
      "relation": "increases_demand_for",
      "to": "CT/NDT evidence"
    },
    {
      "from": "qualification",
      "relation": "depends_on",
      "to": "validated inspection method and acceptance criteria"
    }
  ],
  "research_use_only": true,
  "schema": "addithive-agent-record/v1.1",
  "sources": [
    {
      "id": "source:bottleneck-map",
      "url": "https://addithive.com/additive-manufacturing-bottleneck-map/"
    },
    {
      "id": "source:qualification-guide",
      "url": "https://addithive.com/aerospace-additive-manufacturing-qualification-guide/"
    },
    {
      "id": "source:throughput-guide",
      "url": "https://addithive.com/2023/05/05/scaling-up-high-production-volume-additive-manufacturing-and-3d-printing/"
    }
  ],
  "summary": "Industrial CT can become a downstream constraint when complex AM geometry requires internal defect detection, validated resolution, accepted defect criteria and timely disposition before part release.",
  "valid_as_of": "2026-08-12",
  "why_it_matters": "A printable complex geometry is not production-ready if internal defects cannot be detected and dispositioned at the required rate and confidence."
}